Support Material
You dont have to hold a stock of limonene anymore to use a support material! Check out some of the new support filaments listed here.
Showing 11 of 11 results
-
100% Recycled pellets 3.5OZ PKT
£1.95PELLET material FCHIPS-010 made from 100% recycled HIPS -
Filaprint PVA-M
From: £5.00PVA-M filament is our preferred, cold water soluble, supporting material for dual extruder 3D printing -
Filaprint PVA-S
From: £5.00PVA-S is a specially developed water soluble solution for dual extrusion when you need to print with styrene based materials. -
HIGH T LAY SUPPORT FILAMENT BY KAI PARTHY
From: £2.95HIGH T LAY support filament by Kai Parthy of CC Products. -
High-T-Lay
£3.50A wonderful support material for its shear simplicity of use. Just load, print, soak and remove easily, leaving no residual material stuck to your print -
HIPS by Reprapper Tech Ltd
£1.45HIPS soluble filament by Reprapper Tech Ltd -
Lay-PVA Sample
From: £2.50An excellent water soluble support material by Kai Parthy of CC Products. Superb performance when dual printing, protected against overheating. -
MOLDLAY by Kai Parthy CC Products
£3.95Wax like filament for investment casting or permanent mold casting! -
Polydissolve S1 by PolyMaker
£3.95PolyDissolve™ S1 is a Poly (vinyl alcohol) based filament. PVA has excellent solubility in water. -
PolySupport™ by Polymaker
From: £2.95An easy to remove support filament, that needs no water or limonene to dissolve -
POROLAY LAY-FOMM 40 by Kai Parthy / Lay-Filaments
From: £2.50This material is made from a rubber-elastomeric polymer and a PVA-component.