Gen3 CarbonX™ Carbon Fiber Reinforced Nylon 3D Filament
Gen 3 CarbonX™ CF-Nylon Filament is an advanced semi-aromatic polyamide copolymer reinforced with high-modulus carbon fiber. This filament is ideal for anyone that desires a structural component with high modulus, improved chemical and thermal resistance, excellent surface quality, and ease of printing. Tired of nylon that warps? This is the answer you've been looking for. Excellent dimensional stability comes from the carbon fiber and the semi-aromatic nylon.
Carbon Fiber Printer: Print industrial-grade CF-NYLON parts with Gearbox™ HT2 High-Temp 3D Printer.
High-Performance + High Temp Resistance: Gen3 CarbonX™ CF-Nylon is a PA6 copolymer made using high-modulus carbon fiber and state-of-the-art compounding and extrusion technology. Gen3 has higher HDT than our previous grades (147°C at .45MPa) allowing for expanded use in higher-temp applications.
Open Source: You do not need to purchase a special printer for CarbonX™ CF-Nylon. Our CF Nylon (Gen 3) is suitable for use in practically any desktop 3D Printer that has a heated bed.
Hardened Nozzles: Carbon fiber reinforced filaments are abrasive and can wear out a brass or aluminum nozzle. We recommend our A2 Hardened
- High Modulus Carbon Fiber - excellent stiffness
- Semi-Aromatic Polyamide
- Lower moisture uptake vs. PA6
- Improved chemical resistance vs. PA6
- Less shrinkage / warp vs. PA6
- Low-Gloss Surface
- Excellent Printability
Recommended Print Conditions:
- Extruder: 240-270°C. CarbonX™ CFR Nylon exhibits improved layer bonding at higher temperatures.
- Bed Temp: 100 - 110°C
- Bed Prep: Polyimide Tape, Clean glass with ABS/Acetone Slurry
- Nozzle: 0.4mm or larger. We currently recommend our A2 Hardened Steel Nozzles
- Drying - very important. This product is supplied dry and sealed in thick 4mil pouch with several packs of desiccant. However, it is made using nylon and will absorb more moisture than other resins when left exposed to the environment. Excessive moisture will result in popping at the nozzle (water boiling off, a little steam) and excessive drooling and nozzle build-up. Make sure to keep this filament in a dry location between uses. If the filament does get wet, you can dry it out with a basic toaster oven (not one for the family food!). We recommend drying it for 2-3 hours at 70-80°C. Caution: Make sure to check back often to make sure you're not distorting / melting the reel - the reel itself has lower thermal